25 Asymmetrical Pixie: Long on One Side

The long side of an asymmetrical pixie does most of the work: about five inches swept across the forehead, while the short side can go down to a number one clipper. I cut these dry so I can see where each side falls, and most need a trim every four to six weeks.

1. Asymmetrical Pixie, Swept to the Side

I clipper the short side to a number two on dry hair so it sits above the ear, then point cut the long side to taper toward the cheekbone. In this side swept asymmetrical pixie, a five-inch top crosses the forehead to the cheekbone. It works best with fine to medium density and 1A to 2A texture, on square and oval faces. Use a flat brush to blow-dry the top across. Trim every five weeks.

2. Asymmetrical Pixie Bob, Long to the Jaw

I graduate the nape to the occipital on dry hair, scissor cut the short side to an inch, and angle the long side to the jaw with flat shears. That gives the asymmetrical pixie bob one side at the jaw while the nape and other side stay short and graduated. Medium to thick density with 1A to 2A texture holds the line, on heart and oval faces. A paddle brush blow-dries it flat. Trim every five weeks.

3. Asymmetrical Platinum Pixie Over a Skin Fade

I fade the short side from a zero to a number two on dry hair, cut the long side to five inches, then lift to a level ten and tone violet. Platinum over a skin fade is the highest contrast take on the cut: scalp on one side, white hair on the other. Fine to medium density and cool skin tones fit. Blow-dry the long side over and use a bond builder weekly. Retouch every four weeks.

4. Asymmetrical Curly Pixie With a Taper

I clipper the short side to a taper at the skin on dry hair, then shape the long side curl by curl over one eye, leaving five inches of shrunken length. Curls on an asymmetrical pixie are always cut dry, one curl at a time. Medium to thick density and 3A to 3C texture fit, on heart and oval faces. Work curl cream into wet hair and diffuse on low. Trim every seven weeks.

5. Asymmetrical Pixie After 50

I keep the asymmetry to an inch and a half over 50, sweeping the long side to the cheekbone and scissor cutting the short side instead of clippering it. On dry hair I point cut the long side at four inches and leave two on the short side. Fine to medium density and 1A to 2A texture fit most face shapes. Blow-dry with volumizing mousse and a small round brush. Trim every five weeks.

6. Asymmetrical Pixie Bob and Blunt Fringe

I cut the fringe at the brow with flat shears, giving a horizontal line against the diagonal of the long side on this asymmetrical pixie bob. Before that, the nape is graduated dry, the short side clippered, and the long side angled to the jaw. Fine to medium density and 1A to 1C texture fit, on oblong and oval faces. Blow-dry the fringe down. Trim the fringe every three weeks.

7. Asymmetrical Pixie Razored for Thick Hair

I razor the long side and top at five inches and take out interior bulk, so thick hair on an asymmetrical pixie tapers instead of hanging like a block. The short side and nape are clippered on dry hair first. Thick density with 1A to 2B texture works on any face shape. Rough-dry with a smoothing cream and piece out with paste. Trim every five weeks.

8. Asymmetrical Copper Pixie and Long Bangs

I apply a level seven copper at the root and a demi on the ends, and it looks brightest on the long bangs of this asymmetrical pixie, where they catch light crossing the forehead. The short side is clippered dry, the top cut to four inches, and the bangs angled to the cheekbone. Fine to medium density and warm skin tones fit. Blow-dry the bangs across and finish with serum. Refresh the tone every five weeks.

9. Asymmetrical Pixie and a Disconnected Top

I clipper the short side and nape to a number three on dry hair, then cut the top and long side to six inches without blending. That leaves a hard line between the clippered side and the six-inch top of this asymmetrical pixie. Medium to thick density and 1A to 2A texture hold it, on heart and oval faces. Blow-dry the top over the line and piece it with wax. Trim every four weeks.

10. Asymmetrical Pixie Bob on Fine Hair

I leave the long side blunt on a fine-hair asymmetrical pixie bob, because point cutting would thin the perimeter. On dry hair the short side is scissor cut to an inch, the nape softly graduated, and the long side cut to the jaw with flat shears. Fine density and 1A to 2A texture fit, on round and oval faces. Mousse the damp roots and blow-dry the crown up on a round brush. Trim every five weeks.

11. Wavy Asymmetrical Pixie and a Shaved Side

I leave the long side and top at six inches so the waves have room to bend, and shave the other side to a number one. The short side and nape are clippered on dry hair, then the long side and top are point cut. Medium density with 1C to 2B texture fits, on heart and oval faces. Scrunch sea salt spray into damp hair and rough-dry toward the long side. Shave every two weeks.

12. Asymmetrical Pixie and a Shaved Line

I clipper the short side to a number one on dry hair, trim one line from the temple to the crown, then cut the long side to five inches. The shaved line turns the clipper work on this asymmetrical pixie into a feature. Medium to thick density and 1A to 2B texture fit, on heart and oval faces. Blow-dry the long side over and piece it with wax. Re-cut the line every two weeks.

13. Asymmetrical Pixie Bob in Dark Brunette

I apply a level four demi from root to end, and dark brunette makes the jaw-length diagonal of this asymmetrical pixie read like a drawn line. The nape is graduated on dry hair, the short side clippered, and the long side angled to the jaw. Fine to thick density and neutral or cool skin tones fit. Blow-dry flat on a paddle brush and finish with serum. Refresh the tone every eight weeks.

14. Asymmetrical Pixie for a Round Face

I angle the long side an inch below the jaw and graduate the nape high, because a round face needs the long side past the jaw and height at the crown. The short side is clippered on dry hair. Medium to thick density and 1A to 2B texture fit. Blow-dry the crown up with a round brush, keeping the long side smooth and close to the cheek. Trim every five weeks.

15. Asymmetrical Pixie and Micro Bangs

I cut the bangs an inch above the brow with point cut ends, on a slight diagonal across this asymmetrical pixie. The short side and nape are clippered on dry hair and the top is cut to four inches. Fine to medium density and 1A to 1C texture fit, on heart and oval faces. Use a flat brush to blow-dry the bangs down. Trim the bangs every three weeks.

16. Asymmetrical Pixie Bob in Honey Blonde

I lift to a level eight and tone gold-beige, so honey blonde warms the long side of this jaw-length asymmetrical pixie without brass while the close-cut side stays a shade darker. The nape is graduated dry, the short side clippered, and the long side angled to the jaw. Fine to medium density and warm skin tones fit. Blow-dry the long side smooth and finish with a light oil. Tone every six weeks.

17. Asymmetrical Pixie and an Undercut Nape

I clipper the nape and short side to a number one on dry hair, so on this asymmetrical pixie only the top carries length. The top and long side are cut to five inches with point cut ends. Medium to thick density and 1A to 2B texture fit, on heart and oval faces. Blow-dry the top over and piece with paste. Buzz every two weeks.

18. Asymmetrical Pixie and a Shadow Root

I apply a level six demi at the root and leave the lengths at level nine, which keeps depth at the scalp of a blonde asymmetrical pixie. That matters because the clippered side shows skin. The short side is clippered dry and the long side cut to five inches. Fine to medium density and 1A to 2B texture fit. Blow-dry the top over. Refresh the root every ten weeks.

19. Asymmetrical Pixie Bob, Growing Out

I scissor cut the short side to an inch on dry hair and graduate the nape lightly while the long side of this grown out asymmetrical pixie bob moves past the jaw. Only the ends of the long side get point cut. Fine to thick density and 1A to 2B texture fit any face shape. Blow-dry the long side forward and tuck the short side. Tidy the short side every five weeks.

20. Asymmetrical Pixie With Piecey Texture

I point cut an inch deep into the long side and the top, so this asymmetrical pixie breaks into pieces over the clipped side. The short side and nape are clippered on dry hair and the long side is cut to five inches. Medium to thick density and 1A to 2B texture fit, on square and oval faces. Rough-dry using texture spray and piece with paste. Trim every five weeks.

21. Asymmetrical Pixie for a Square Face

I angle the front below the cheekbone with point cut ends, so the long side of this asymmetrical pixie sweeps past the cheekbone and softens the corner of the jaw. The short side and nape are clippered dry and the long side cut to five inches. Medium to thick density and 1A to 2B texture fit. Blow-dry the crown up and the long side across. Trim every five weeks.

22. Asymmetrical Pixie Bob on Gray Hair

I angle the long side to the jaw with flat shears, and gray hair there reads bright against the darker close-cut side of this asymmetrical pixie. The nape is graduated on dry hair and the short side scissor cut to an inch. Fine to medium density and 1A to 2A texture fit any face shape. Use a round brush to blow-dry and finish with violet-toned serum. Trim every five weeks.

23. Asymmetrical Pixie With One Framing Piece

I leave one temple piece on the long side at six inches and point cut it, giving this asymmetrical pixie a single line that falls past the cheekbone. The short side and nape are clippered on dry hair and the top goes to four inches. Fine to thick density and 1A to 2B texture fit, on round and square faces. Blow-dry the top over and the piece forward. Trim every five weeks.

24. Flat-Combed Sleek Asymmetrical Pixie

I clipper the short side and nape to a zero on dry hair, then cut the long side to five inches with flat shears, so the diagonal of this asymmetrical pixie shows as one clean edge across the forehead. Fine to thick density and 1A to 1C texture fit, on square and oval faces. Blow-dry flat on a paddle brush, smooth with a flat iron, and finish with serum. Trim every four weeks.

25. Asymmetrical Pixie Bob for Air-Drying

I point cut deep into the ends of the long side, so this asymmetrical pixie bob air-dries into pieces. The short side is clippered dry, the nape softly graduated, and the long side angled to the jaw. Fine to medium density and 1C to 2B texture fit any face shape. Smooth a light cream into damp hair, push the long side forward, and leave it. Trim every six weeks.

Closely related: short haircuts for women and wispy bangs.

An asymmetrical pixie turns on the long side swept forward and the short side clipped close, because that off-balance line is what gives it edge. Tuck the short side back and the shape opens up.

Trophywifestyle
🛋️ Passionate about home decor, fashion, interior design, and exploring the world 🌎 Join me as I curate stylish spaces and seek out adventure!
Scroll to Top