Round Face, Double Chin: Length Past the Jaw

Most of the hair I cut for a round face and double chin lands at or just past the collarbone, because that length pulls the eye down past the jaw instead of stopping at it. The rest happens at the crown, where a round brush and root spray add height that makes the face read longer.

1. Long Layers Below the Collarbone

Long layers past the collarbone are where I start with hair for round face shape double chin clients, since that length takes the eye below the chin. I cut the perimeter on dry hair two inches below the collarbone and point cut layers that begin under the chin, never at it. Good for fine to thick density and 1A to 2B texture. Round-brush it dry for lift at the root. Trim every eight weeks.

2. Angled Lob Dropping Longer at the Front

An angled lob that runs longer at the front sets a diagonal next to the jaw and drags the eye down past the chin. I cut the back to the shoulder on dry hair, angle the front two inches longer, and point cut the ends. On a round face with a double chin it suits fine to medium density with 1A to 2A texture. Round-brush it smooth using a smoothing cream. Trim every six weeks.

3. Deep Side Part and Long Swept Bangs

A deep side part paired with long side swept bangs lays a diagonal over the face and interrupts the roundness. I point cut the perimeter at the collarbone on dry hair, then cut the bangs from the part down to the jaw. Suits fine to medium density with 1A to 2B texture. Use a flat brush to dry the bangs across, and a round brush to lift the crown. Trim the bangs every five weeks.

4. Hair for Round Face Shape Double Chin With Lift at the Crown

The hair for round face shape double chin detail that counts most is crown volume, because height on top makes the face read longer. I point cut the perimeter at the collarbone on dry hair, then point cut short internal crown layers for lift. Fine to medium density with 1A to 2A texture. Round-brush the crown up and over, then set it with root spray. Trim every eight weeks.

5. Shoulder-Length Layers With a Below-Chin Face Frame

A face frame starting below the chin leaves the jaw untouched and draws a line down the neck. I point cut the perimeter at the shoulder on dry hair, then point cut the face frame from an inch under the chin down to the collarbone. On a round face it suits fine to thick density and 1A to 2B texture. Round-brush the face frame away from the face. Trim every eight weeks.

6. Long Pixie With Lift on Top

A long pixie with height works on a round face with a double chin if the sides stay tight and the top goes up. I scissor over comb the sides and nape on dry hair, leave five inches on top, and point cut it. Fine to medium density with 1A to 2A texture. Round-brush the top up and back, then set it with texture paste. Trim every five weeks.

7. Hair for Round Face Shape Double Chin Over 50: Layered Collarbone Cut

A collarbone cut with long layers, a side part, and a long side fringe is the hair for round face shape double chin over 50 I cut more than anything. I point cut the perimeter at the collarbone on dry hair, point cut layers starting below the chin, and cut the fringe from the part to the jaw. Fine to medium density with 1A to 2A texture. Round-brush it dry. Trim every eight weeks.

8. Inverted Bob Cut Past the Chin

An inverted bob with the front an inch past the chin keeps the line angled and clear of the jaw. On dry hair I graduate the nape, build the weight line at the occipital, and angle the front down beyond the chin. On a round face with a double chin it suits fine to thick density and 1A to 2A texture. Round-brush it, turning the front under and lifting the crown. Trim every six weeks.

9. Long Beach-Waved Hair

Beach waves on long hair hold the volume below the shoulder and off the face. I point cut the perimeter three inches below the collarbone on dry hair, then point cut long layers that start under the chin. On a round face it suits medium to thick density with 1B to 2C texture. Wave with a one-inch iron from the collarbone downward and keep the roots smooth. Trim every ten weeks.

10. Collarbone Lob With a Side Part

A collarbone lob with a side part is the shortest I go on a round face with a double chin when there’s no fringe. I point cut the perimeter at the collarbone on dry hair, part on the heavier side, and point cut one layer under the chin. Fine to medium density with 1A to 2B texture. Round-brush it, turning the ends under and lifting the root. Trim every eight weeks.

11. Shoulder-Length Cut With Long Curtain Bangs

Curtain bangs falling past the cheekbone narrow a round face with no added width at the brow. I point cut the perimeter at the shoulder on dry hair, section out a triangle, and cut the bangs from the cheekbone to the jaw so they stay long. Fine to medium density with 1B to 2B texture. Use a small round brush to blow the bangs out, then lift the crown. Trim the bangs every six weeks.

12. Hair for Round Face Shape Double Chin Over 60: Shoulder Cut With Height

My take on hair for round face shape double chin over 60 keeps the perimeter at the shoulder with long layers and crown height. On dry hair I point cut the perimeter, point cut layers starting below the chin, and cut short crown layers for lift. Fine to medium density with 1A to 2A texture. Round-brush the crown up with mousse. Trim every eight weeks and gloss every eight.

13. Long Shag Cut

A long shag piles the layers at the crown and lets the length drop past the collarbone, so volume sits up top. I cut the perimeter beyond the collarbone on dry hair, point cut short crown layers, and razor the face frame starting below the chin. On a round face it suits medium to thick density with 1B to 2C texture. Rough-dry using a texture spray and push the crown up. Trim every eight weeks.

14. Sleek Long Hair Parted in the Center

Sleek long hair parted in the center draws two straight lines down both sides of a round face. I point cut the perimeter four inches below the collarbone on dry hair and leave the interior solid. On a round face with a double chin it suits medium to thick density with 1A to 1C texture. Dry it flat using a paddle brush, flat iron with heat protectant, and finish with serum. Trim every ten weeks.

15. Shoulder-Length Waves and a Side Part

Shoulder length waves with a side part keep the bend under the chin so nothing widens the jaw. I point cut the perimeter at the shoulder on dry hair and add a single layer below the chin. On a round face it suits fine to medium density with 1B to 2B texture. Wave with a one-inch iron from the chin down, keep the roots smooth, and break it up with a light spray. Trim every eight weeks.

16. Curly Hair Cut Past the Shoulders

Curly hair past the shoulder sets the width under the chin and the height at the crown. On dry hair I cut the perimeter beyond the shoulder curl by curl, then layer from below the chin so curl won’t bunch at the jaw. On a round face with a double chin it suits medium to thick density with 3A to 3C texture. Rake curl cream through wet hair and diffuse on a low setting. Trim every ten weeks.

17. Hair for Round Face Shape Double Chin in Balayage

Balayage keeps the jaw deep and the ends light, which pulls the eye down a round face. I point cut the perimeter at the collarbone on dry hair with long layers, then hand paint to a level nine from the collarbone down, leaving the face frame dark at the jaw. Fine to thick density with 1A to 2B texture. Refresh every twelve weeks.

18. Pixie With a Long Side Fringe

A pixie with a long side fringe gives a round face with a double chin a diagonal and height at the same time. I scissor over comb the sides and nape on dry hair, leave four inches on top, and cut the fringe from the part to the cheekbone. Fine to medium density with 1A to 2A texture. Dry the fringe across and the crown up, then set with paste. Trim every five weeks.

19. Long Layers and Wispy Side Bangs

Wispy side bangs soften the forehead without the width a full fringe gives a round face. I point cut the perimeter past the collarbone on dry hair with long layers, then cut the bangs on a diagonal from brow to cheekbone and point cut them. Fine to medium density with 1A to 2A texture. Use a small brush to dry the bangs across. Trim the bangs every four weeks.

20. Razor-Cut Collarbone Lob

A razor cut lob at the collarbone keeps soft ends, so no hard line sits near the jaw. On dry hair I cut the perimeter at the collarbone, razor the last two inches, and razor face framing pieces starting under the chin. On a round face with a double chin it suits medium to thick density with 1B to 2B texture. Rough-dry using a light cream and lift the crown with your fingers. Trim every eight weeks.

21. High Ponytail and Face-Framing Pieces

A high ponytail with two face framing pieces lifts the hair up and away while leaving a line down each side. I point cut the perimeter past the collarbone on dry hair, then cut two face framing pieces from the cheekbone to the chin. On a round face it suits fine to thick density with 1A to 2B texture. Tease the crown, secure the ponytail high, and curl both pieces away from the face.

22. Shoulder-Length Cut With Lift at the Root

On a shoulder length cut, root lift lengthens a round face more than the perimeter can. I point cut the perimeter at the shoulder on dry hair, then point cut short internal layers at the crown. On a round face with a double chin it suits fine to medium density with 1A to 2A texture. Spray a root spray on damp hair and round-brush the crown up and over. Trim every eight weeks.

23. Dark Brunette Layers Past the Collarbone

Dark brunette on long layers keeps contrast around the face low and draws the eye to movement below the chin. I point cut the perimeter past the collarbone on dry hair with long layers, then apply a level four demi from root to end. On a round face it suits fine to thick density and cool or neutral skin tones. Round-brush it dry and finish with serum. Refresh the tone every eight weeks.

24. Half-Up Style With Volume at the Crown

A half up style with crown volume builds height and keeps length running down the sides of a round face. I point cut the perimeter past the collarbone on dry hair with long layers starting under the chin. On a round face with a double chin it suits fine to thick density with 1A to 2B texture. Tease the crown, pin the top half back at the occipital, and wave the rest from the chin down.

25. Copper Collarbone Lob With a Side Part

A copper collarbone lob brightens the face and keeps attention on the color. I point cut the perimeter at the collarbone on dry hair, point cut a single layer below the chin, and then apply a level seven copper. On a round face with a double chin it suits fine to medium density and warm skin tones. Round-brush it dry, part to one side, and finish with serum. Refresh the tone every five weeks.

Closely related: low maintenance haircut for thick hair and hairstyles for thick curly hair.

Hair for a round face with a double chin lands at the collarbone with a side part, because that length pulls the eye down past the jaw instead of stopping at it. A copper tone keeps the attention on the color.

Trophywifestyle
🛋️ Passionate about home decor, fashion, interior design, and exploring the world 🌎 Join me as I curate stylish spaces and seek out adventure!
Scroll to Top