A shag haircut for a round face comes down to two things: short layers at the crown for height, and a face frame that starts at the chin instead of the cheekbone. I cut all of these dry so I can see where the layers fall, and most need just texture spray, a rough-dry, and a trim every eight weeks.
1. Long Shag Featuring Crown Layers

The cut I give shag haircut round face clients first is a long shag with crown layers: the height stays up top and the length falls past the collarbone. Working dry, I take the perimeter past the collarbone, point cut short layers at the crown, then razor a face frame starting at the chin. Best on medium to thick density with 1B to 2C texture. Push the crown up while you rough-dry with texture spray. Trim every eight weeks.
2. Collarbone-Length Shag With Curtain Bangs
This collarbone shag with curtain bangs puts two diagonals around a round face while the volume stays at the crown. Working dry, I cut the perimeter to the collarbone, point cut layers starting at the chin, section a triangle, and take the bangs from cheekbone down to jaw. Best on fine to medium density with 1B to 2B texture. Rough-dry everything except the bangs, which you blow out with a small round brush. Trim the bangs every five weeks.
3. Razor-Cut Long Shag
Every end on this razor cut long shag stays soft, which means no horizontal line lands at the cheek. Working dry, I razor the perimeter past the collarbone, razor layers starting below the chin, and razor the crown short so it lifts. Best on a round face with medium to thick density and 1B to 2B texture. Use a light cream to rough-dry, flip your head over for the crown, and leave the ends however they fall. Trim every eight weeks.
4. Long Shag Haircut Round Face Parted to the Side
This everyday long shag haircut round face clients like carries a deep side part to interrupt the roundness at the forehead. Working dry, I take the perimeter past the collarbone, point cut the crown layers, razor the face frame starting at the chin, and part toward the heavier side. Best on fine to thick density with 1A to 2B texture. Rough-dry using texture spray, then push the heavy side back. Trim every eight weeks.
5. Medium Shag Framed Under the Chin
This shoulder-length medium shag flatters a round face because the face frame begins under the chin instead of at the cheek. Working dry, I cut the perimeter to the shoulder, point cut short layers at the crown, and razor the face frame starting an inch below the chin. Best on fine to medium density with 1B to 2B texture. Rough-dry using texture spray and lift the crown with your fingertips. Trim every eight weeks.
6. Wolf Cut on a Round Face
This wolf cut stacks a short crown on a round face and lets the length run past the shoulder, making the shape tall, not wide. Working dry, I cut the perimeter below the shoulder, point cut the crown layers to three inches, and razor the lengths plus the face frame starting at the chin. Best on medium to thick density with 1B to 2C texture. Push the crown up while you rough-dry with texture spray. Trim every eight weeks.
7. Collarbone Shag Haircut Round Face Over 50
My shag haircut round face cut for clients over 50 is a collarbone shag carrying long layers and a long side fringe. Working dry, I cut the perimeter to the collarbone, point cut layers starting below the chin, point cut short layers at the crown, and take the fringe from the part down to the jaw. Best on fine to medium density with 1A to 2A texture. Blow the crown up using a round brush. Trim every eight weeks.
8. Curly Shag Below the Shoulder
This curly shag past the shoulder stacks the curl at the crown and keeps the length below the chin. Working dry and curl by curl, I cut the perimeter past the shoulder, take short layers at the crown so the curl lifts, and cut the face frame starting below the chin. Best on a round face with medium to thick density and 3A to 3C texture. Diffuse on low after raking curl cream through wet hair. Trim every ten weeks.
9. Wavy Collarbone-Length Shag
This wavy shag at the collarbone sets the bend below the chin and keeps the lift at the crown. Working dry, I cut the perimeter to the collarbone, point cut the crown layers, and razor the ends. Best on a round face with fine to medium density and 2A to 2C texture. Scrunch sea salt spray through damp hair, part it to one side, and let it air-dry with the crown clipped up for ten minutes. Trim every eight weeks.
10. Long Shag Haircut Round Face Plus Wispy Bangs
This long shag haircut round face clients wear gets wispy bangs that soften the forehead without any added width. Working dry, I take the perimeter past the collarbone, point cut the crown layers, razor the face frame starting at the chin, and cut the bangs at the brow, point cutting deep into them. Best on fine to medium density with 1A to 2A texture. Rough-dry the rest and blow the bangs down. Trim the bangs every four weeks.
11. Shag Cut for Fine Hair
This fine-hair shag gets fewer layers, which leaves weight in the ends. Working dry, I cut the perimeter to the collarbone with point cut ends, point cut just three crown layers, and point cut the face frame starting at the chin. Best on a round face with fine density and 1A to 2A texture. Blow the crown up with a round brush after putting mousse on damp roots. Trim every six weeks.
12. Shag Cut for Thick Hair
This thick-hair shag takes internal layers through the sides, which pulls the width out of the cheek area. Working dry, I take the perimeter past the collarbone, point cut the crown layers, razor internal layers through the sides, and razor the face frame starting at the chin. Best on a round face with thick density and 1B to 2C texture. Rough-dry using a light cream, adding texture spray at the crown. Trim every eight weeks.
13. Shoulder-Length Shag Haircut Round Face Over 60
My shag haircut round face cut for clients over 60 keeps the perimeter at the shoulder, with soft layers, lift at the crown, and a side swept fringe. Working dry, I cut the perimeter with point cut ends, point cut layers starting below the chin, point cut short layers at the crown, and take the fringe to the cheekbone. Best on fine to medium density with 1A to 2A texture. Use mousse and blow the crown up. Trim every eight weeks and gloss every eight.
14. Seventies Shag Parted in the Center
This seventies shag with a center part suits a round face as long as the crown stays short and the face frame starts under the chin. Working dry, I take the perimeter past the collarbone, point cut the crown to three inches, and razor the face frame starting at the chin. Best on medium to thick density with 1B to 2B texture. Rough-dry the crown and blow the face frame back with a round brush. Trim every eight weeks.
15. Shaggy Lob Featuring a Side Swept Fringe
This shaggy lob with a side swept fringe holds the perimeter at the collarbone and lays a diagonal across the forehead. Working dry, I cut the perimeter to the collarbone, point cut the crown layers, razor the ends, and take the fringe from the part to the cheekbone. Best on a round face with fine to medium density and 1A to 2B texture. Rough-dry the rest and blow the fringe across with a flat brush. Trim every six weeks.
16. Shullet Left Long
This shullet with length keeps short, close sides, a tall crown, and a back that runs long past the shoulder. Working dry, I cut the sides scissor over comb, point cut the crown to four inches, and razor the back long. Best on a round face with medium to thick density and 1B to 2C texture. Push the crown up while you rough-dry with texture paste. Trim the sides every five weeks.
17. Long Shag Haircut Round Face Finished With Balayage
The balayage on this long shag haircut round face clients wear puts the brightest pieces on the ends and keeps the cheek area deep. Working dry, I take the perimeter past the collarbone, point cut the crown layers, razor the face frame starting at the chin, and hand paint to a level nine from the chin down. Best on fine to thick density with 1B to 2B texture. Rough-dry using texture spray. Refresh every twelve weeks.
18. Short Shag Built for Height
This short shag with height suits a round face because the perimeter clears the jaw and the crown goes up. Working dry, I cut the perimeter an inch below the chin, point cut the crown to three inches, and razor the sides to sit flat. Best on fine to medium density with 1B to 2B texture. Rough-dry using texture paste, push the crown up, and keep the sides tight to the head. Trim every six weeks.
19. Shag Featuring Long Curtain Bangs
The long curtain bangs on this shag drop from cheekbone to jaw, narrowing the face rather than widening it. Working dry, I cut the perimeter to the collarbone, point cut the crown layers, section a triangle, and take the bangs from the cheekbone down to the jaw. Best on a round face with fine to medium density and 1B to 2B texture. Blow the bangs out using a small round brush. Trim the bangs every six weeks.
20. Copper-Toned Long Shag
This copper long shag warms up the face and keeps attention on the color and the movement. Working dry, I take the perimeter past the collarbone, point cut the crown layers, razor the face frame starting at the chin, and apply a level seven copper. Best on a round face with fine to medium density and warm skin tones. Rough-dry using texture spray, then finish the ends with serum. Refresh the tone every five weeks.
21. Shag Haircut Round Face Parted Deep to the Side
The shag haircut round face change I make before I cut anything is a deep side part, because it lays a diagonal across the forehead. Working dry, I cut the perimeter to the collarbone, point cut the crown layers, razor the face frame starting at the chin, and part two inches off center. Best on fine to thick density with 1A to 2B texture. Rough-dry using texture spray, then push the heavy side back. Trim every eight weeks.
22. Choppy Shoulder Shag
This choppy shag at the shoulder gets deep point cutting through each layer, which separates the pieces and lifts the crown. Working dry, I cut the perimeter to the shoulder, point cut the crown layers, and point cut deep into the face frame starting at the chin. Best on a round face with medium to thick density and 1B to 2B texture. Rough-dry using texture paste and pull the pieces apart with your fingers. Trim every eight weeks.
23. Feathered Shag Cut
This feathered shag blows the face frame back off the cheek, and that narrows a round face. Working dry, I take the perimeter past the collarbone, point cut the crown layers, and cut the face frame starting at the chin with the shears angled outward. Best on fine to medium density with 1A to 2A texture. Blow the face frame back and the crown up with a round brush, then set it with a light spray. Trim every eight weeks.
24. Dark Brunette Shag Worn Long
This dark brunette long shag keeps contrast around the face low, so the layers show up as movement, not width. Working dry, I take the perimeter past the collarbone, point cut the crown layers, razor the face frame starting at the chin, and apply a level four demi root to end. Best on a round face with fine to thick density and cool or neutral skin tones. Rough-dry using texture spray. Refresh the tone every eight weeks.
25. Soft Long Shag Haircut Round Face Over 40
The long shag haircut round face cut my clients over 40 request has soft layers, a lifted crown, and a face frame that starts at the chin. Working dry, I take the perimeter past the collarbone, point cut the crown layers, and point cut the face frame starting at the chin. Best on fine to medium density with 1A to 2B texture. Blow the crown up using a round brush, with smoothing cream through the ends. Trim every eight weeks.
You might also like modern shag haircut and curly shag haircut.
A long shag haircut on a round face lives in the layers past the cheek, because that is what keeps the width from building at the side. The choppy crown lifts without adding bulk at the jaw.
























