Most of the cuts I give a long, narrow face land between chin and collarbone, usually with a fringe or curtain bangs taking length off the forehead. Good hair for a rectangle face shape puts width at the cheekbone and softens the corners of the jaw, and a round brush or one-inch iron does most of the styling work.
1. Collarbone-Length Waves and Curtain Bangs

Collarbone waves with curtain bangs are my first pick of hair for rectangle face shape clients: the bangs shorten the forehead, and the waves widen the cheekbone. I point cut the perimeter at the collarbone on dry hair, section out a triangle, and cut the bangs from the brow down to the cheekbone. Good for fine to medium density and 1B to 2B texture. Wave using a one-inch iron. Trim every eight weeks.
2. Soft Layered Bob Cut Past the Chin
A soft layered bob an inch past the chin clears the jaw, and the point cut layers soften its corners. I point cut the perimeter on dry hair, then point cut layers through the sides from the cheekbone downward. On a rectangle face it suits fine to medium density with 1A to 2B texture. Round-brush it, rolling under, with a smoothing cream. Trim every six weeks.
3. Wispy Fringe and Shoulder-Length Layers
A wispy fringe takes length off the forehead minus the hard line a blunt fringe draws. I cut it at the brow on dry hair and point cut deep, then take the length to the shoulder with layers beginning at the cheekbone. On a rectangle face it suits fine to medium density and 1A to 2A texture. Use a small brush to dry the fringe down and a round brush on the length. Trim the fringe every four weeks.
4. Hair for Rectangle Face Shape With a Side Part
The hair for rectangle face shape change I make first is a side part, since it interrupts the long line down the center. I point cut the perimeter at the collarbone on dry hair, then point cut layers starting at the cheekbone. Fine to thick density with 1A to 2B texture. Round-brush it, part on the heavier side, and turn the ends under. Trim every eight weeks.
5. Shoulder-Length Shag With a Fringe
A shoulder length shag with a fringe adds texture at the cheekbone and jaw and covers the forehead. I cut the fringe at the brow on dry hair, point cut short layers starting at the cheekbone, then razor the ends at the shoulder. On a rectangle face it suits medium to thick density with 1B to 2C texture. Rough-dry using a texture spray and push the sides out. Trim every eight weeks.
6. Pixie With a Side-Swept Fringe
On a rectangle face a pixie with a side swept fringe works if the top stays low and the fringe sweeps over the forehead. I scissor over comb the sides and nape on dry hair, leave three inches on top, then cut the fringe from the part to the cheekbone. Fine to medium density with 1A to 2A texture. Use a flat brush to dry the fringe across and keep the crown flat. Trim every five weeks.
7. Hair for Rectangle Face Shape Over 50: Layered Chin Bob
A chin length bob with soft layers and a side swept fringe is the hair for rectangle face shape over 50 that I cut more than anything else. I point cut the perimeter an inch below the chin on dry hair, point cut layers from the cheekbone, and cut the fringe from the part to the cheekbone. Fine to medium density with 1A to 2A texture. Round-brush it dry with a smoothing cream. Trim every six weeks.
8. Layered Collarbone Lob and Curtain Bangs
Curtain bangs on a layered lob hide the forehead and open out at the cheekbone, so a rectangle face reads shorter and wider together. I point cut the perimeter at the collarbone on dry hair, point cut layers starting at the chin, and cut the bangs from the brow down to the cheekbone. Fine to medium density with 1B to 2B texture. Use a small round brush to blow the bangs out. Trim the bangs every five weeks.
9. Beach Waves Cut at the Shoulder
Beach waves at the shoulder widen the cheekbone and soften the jaw’s corners on their way past it. I point cut the perimeter at the shoulder on dry hair and add a single long layer at the chin. On a rectangle face it suits fine to medium density with 1B to 2C texture. Scrunch sea salt spray through damp hair, part to one side, and let it air-dry. Trim every eight weeks.
10. Chin-Length Bob With Curtain Bangs
A chin length bob with curtain bangs holds the perimeter just beyond the jaw, with the bangs falling to the cheekbone. I point cut the perimeter an inch below the chin on dry hair, section out a triangle, and cut the bangs from the brow down to the cheekbone. On a rectangle face it suits fine to medium density with 1B to 2B texture. Use a small round brush to blow the bangs out. Trim the bangs every five weeks.
11. Full Fringe and Soft Long Layers
A full fringe on long hair cuts down the forehead, while soft layers from the cheekbone keep the jaw from looking hard. I cut the fringe at the brow on dry hair, then point cut layers from the cheekbone down to the collarbone. On a rectangle face it suits medium to thick density with 1A to 1C texture. Dry the fringe down and round-brush the length. Trim the fringe every four weeks.
12. Hair for Rectangle Face Shape Over 60: Soft Chin Cut
My approach to hair for rectangle face shape over 60 is a chin-level perimeter with soft layers and a point cut fringe at the brow. On dry hair I point cut the perimeter an inch below the chin, point cut layers from the cheekbone, and cut the fringe at the brow. Fine to medium density with 1A to 2A texture. Round-brush it dry. Trim every six weeks and gloss every eight.
13. Razor-Cut Collarbone Lob
A razor cut lob has soft ends at the collarbone and razored face framing pieces that blur the jaw line. On dry hair I cut the perimeter at the collarbone, razor the last two inches, and razor the face frame starting at the cheekbone. On a rectangle face it suits medium to thick density with 1B to 2B texture. Rough-dry using a light cream and leave the ends where they land. Trim every eight weeks.
14. Side-Parted Layered Lob With Waves
A layered lob with waves and a side part sets the bend next to the cheekbone and jaw. I point cut the perimeter at the collarbone on dry hair, point cut layers starting at the cheekbone, and part on the heavier side. On a rectangle face it suits fine to medium density with 1B to 2B texture. Wave away from the face with a one-inch iron, then break it up with a light spray. Trim every eight weeks.
15. Wavy Bob Cut Past the Chin
A wavy bob an inch past the chin sets the bend at the jaw, softening the corners of a rectangle face. I point cut the perimeter on dry hair and leave the interior solid. Fine to medium density with 2A to 2C texture. Scrunch sea salt spray through damp hair, part it to one side, and leave it to air-dry. Trim every six weeks.
16. Curly Shoulder-Length Cut With a Fringe
A curly shoulder length cut with a fringe gives a rectangle face cheekbone width and forehead cover. On dry hair I cut the perimeter at the shoulder curl by curl, layer from the cheekbone, then cut a curly fringe to the brow. Suits medium to thick density with 3A to 3C texture. Rake curl cream through wet hair and diffuse on a low setting. Trim every eight weeks.
17. Bottleneck Bangs on Long Layers
Bottleneck bangs stay narrow at the brow and spread at the cheekbone, covering the forehead and adding width exactly where a rectangle face wants it. I point cut the perimeter past the collarbone on dry hair with layers from the cheekbone, then cut the bangs short through the center and longer toward the cheekbone. Fine to medium density with 1B to 2B texture. Dry the bangs with a small round brush. Trim every four weeks.
18. Hair for Rectangle Face Shape With Face-Framing Layers
On a rectangle face, face framing layers soften the jaw more than anything, since they begin at the cheekbone and curve outward ahead of the chin. I point cut the perimeter at the shoulder on dry hair, then point cut the face frame from the cheekbone down to the collarbone. Fine to thick density with 1A to 2B texture. Round-brush the face frame away from the face. Trim every eight weeks.
19. Side-Swept Fringe on a Chin-Length Bob
A side swept fringe on a chin length bob lowers the forehead and adds a diagonal. I point cut the perimeter an inch below the chin on dry hair, then cut the fringe from the part to the cheekbone, point cutting the ends. On a rectangle face it suits fine to medium density with 1A to 2A texture. Use a flat brush to dry the fringe across and turn the bob under. Trim every six weeks.
20. Textured Crop With a Long Fringe
A textured crop with a long fringe keeps the sides tight and pushes the weight forward over the forehead. On dry hair I scissor over comb the sides, point cut the top to three inches, and leave the fringe at the brow, point cutting it. On a rectangle face it suits fine to medium density with 1B to 2B texture. Rough-dry using a texture paste and push the fringe to one side. Trim every five weeks.
21. Shoulder-Length Cut and Soft Fringe Over 40
A shoulder length cut with a soft fringe gives a rectangle face over 40 forehead cover and jaw movement. I point cut the perimeter at the shoulder on dry hair, cut the fringe at the brow and point cut it, then add layers starting at the cheekbone. Fine to medium density with 1A to 2B texture. Round-brush it dry with a smoothing cream. Trim every eight weeks.
22. Balayage on Collarbone Waves
Balayage on collarbone waves sets the brightest pieces at the cheekbone and keeps the jaw deep, so the corners fade back. I point cut the perimeter at the collarbone on dry hair with layers from the cheekbone, then hand paint to a level nine from the cheekbone down. On a rectangle face it suits fine to thick density with 1B to 2B texture. Wave using a one-inch iron. Refresh every twelve weeks.
23. Curtain-Banged Wolf Cut
A wolf cut with curtain bangs has short crown layers that fall to the sides, plus bangs over the forehead. On dry hair I section out a triangle and cut the bangs to the cheekbone, point cut the short crown layers, then razor the lengths beyond the shoulder. On a rectangle face it suits medium to thick density with 1B to 2C texture. Rough-dry using a texture spray and push the crown out rather than up. Trim every eight weeks.
24. Angled Bob With Point-Cut Edges
An angled bob landing below the chin in front sets a diagonal by the jaw, and point cutting keeps that line from looking sharp. On dry hair I cut the nape an inch shorter than the front, hold the front an inch below the chin, and point cut the entire perimeter. On a rectangle face it suits fine to thick density with 1A to 2A texture. Round-brush it, turning under. Trim every six weeks.
25. Copper Lob and Curtain Bangs
A copper lob with curtain bangs warms the face and keeps attention on the color at the cheekbone. I point cut the perimeter at the collarbone on dry hair, cut curtain bangs to the cheekbone, and then apply a level seven copper. On a rectangle face it suits fine to medium density and warm skin tones. Blow the bangs out over a round brush, then add serum. Refresh the tone every five weeks.
For more, see long shag haircut round face and modern shag haircut.
Hair for a rectangle face shape needs the corners broken with soft layers and a fringe, since the straight length only echoes the shape. A middle part with waves across the temple is what moves the eye off the parallel lines.
























